falls
extensions
wigs
fringe/streaks
gallery
pre made
colour

Hot to wear your loose falls.



Tools: Comb/brush, hair bobbles, hair pins/kirby grips. Optional: hair band, strip of material, scarf etc



Firstly you need to section off your hair down the middle and tie into two pigtails on top of your head, not too far back, and quite close together. (for a single fall, a high ponytail on top of your head is needed.)



Using a comb, or your fingers, poke a hole, under the bobble, big enough to fit the fall through.



Push the top of the fall through the hole, pulling the elastic out the bottom. Then tighten up your pony tail so its pushing the fall tight against your scalp.



Tie the elastic band from the fall around your ponytail.



Flip the fall over the top of the ponytail so it is hanging down.
Move about until you are happy with how it looks .



Once you have both falls in place, then you can add your hair band or other bits and pieces. If you feel your falls don't feel secure, then you can get a strip of hair bobble/material/scarf/legs from a pair of tights etc, and tie it around the base of the falls/ponytail to help secure it in place and cover up and joins or showing bits of hair. This isn't nessecery but can help the falls stay in without worrying about them flying off your head! .

To cover the front of your hair like in the picture, just grab a couple of sections from the front of the falls and cross them over each other, use pins or grips to keep them in place .

It make take you a few attempts to get it right, just practise with them until you find what best suits you.


Care and information for loose falls.



To take care of your falls is simple.
There are a few ways to increase the life of your falls and following these guidelines will give you the most out of your falls.



If you have any questions that haven't been answered or you do not understand anything, please email us.